banner

Knowledge

Home>Knowledge

Causes and countermeasures of uneven size and length of pellets produced by pellet machines

2025-04-07 09:51:52


The main reasons for the uneven size and length of pellets are as follows: In terms of molds, the opening is unreasonable, the difference between the die hole guide port is too large or the ring die is not concentric. It is necessary to configure a reasonable parameter mold and replace the mold. Raw materials and modulation links: Uneven mixing of raw materials and uneven modulation. The raw materials should be fully mixed, and steam and water should be added at multiple points when adjusting. During the operation of the pellet machine, the feeding amount is uneven, the mold is blocked, the pressure roller is uneven, the motor is damaged or the power is unstable. It is necessary to feed reasonably and evenly, stop the machine to clean the mold, check the pressure roller and ensure that the motor is normal. In addition, unreasonable position or angle of the cutter and non-standard operation of the operator will also cause problems. The cutter needs to be adjusted and the operation is standardized.

If you want to know more about our pellet machine, welcome to subscribe to our YouTube channel.