banner

Knowledge

Home>Knowledge

Causes and solutions for pellet machine blockage?(1)

2025-01-15 10:33:40


The reasons and solutions for pellet machine blockage are as follows:

1. The feed rate is uneven. Solution: Increase the feed rate from low speed to high speed when starting. The feed rate should be even

2. The material volume is too large, the solution is to crush it again

3. The roller is loose. Solution: Stop the machine for inspection and adjust the roller gap.

4. The voltage is too low. Solution: add a distribution room or configure a transformer, and control the current according to the specified load.

5. The die hole of the ring die is clogged. Solution: stop the machine, open the silo, clean out the material, take out the die, and carefully polish the die discharge hole.

If you want to know more about our pellet machine, welcome to subscribe to our YouTube channel.